Home > Power Supply > Power Supply Wont Boot Mobo Inside Case

Power Supply Wont Boot Mobo Inside Case

Contents

Ask a question and give support. permalinkembedsavegive gold[–]Ulfandu 0 points1 point2 points 2 years ago(0 children)Can you post pictures of all the stand-offs on the case? Sorry, there was a problem flagging this post. Also tried different battery. -Remove RAM, hard disk and CD drive. http://macland.net/power-supply/power-supply-from-case.php

With electrical shorts it can be fairly finicky, like I said before its pretty much just pull it out and put it back in and hope this time it works. Flag Permalink This was helpful (0) Collapse - Similar problem - need some advice by juliana007 / October 16, 2007 1:25 PM PDT In reply to: correction Quick sum up of Check your pattern. You said you pulled the 20-pin plug part-way out, and saw some life in the system.

Motherboard Works Outside Of Case But Not In

This will solve many issues, particularly those that crop up when you're installing a new motherboard for the first time. A non-bootable scenario could mean that one, or more, of the preceding components possesses a fault or suffers from improper connection. Ummm..no, didn't work out that way. When i Wiki'd it some electronic board came up.

  1. Doh.
  2. If not you'll get the next step to try [we are doing fault isolation, if it isn't obvious].
  3. Whether you’re using a desktop computer or a laptop, your computer’s motherboard contains an integrated battery.
  4. The psu will take care of motherboard grounding.I think there has to be a short somewhere.Can you put parts back into the case, one by one, and see which part the
  5. This tells you which pins are the "start" button.

The led on the front lights up, and it sounds like it's starting up, but nothing shows up. Do you have the system connected to a good surge suppressor? Also, check that all internal wires are properly shielded with a rubber or plastic exterior. James covered how to diagnose unbootable computers How To Diagnose Hardware Problems When Your Computer Won't Turn On How To Diagnose Hardware Problems When Your Computer Won't Turn On Last week

All that the mobo power control circuit does is tie the green wire to a logic low when you hit the power on switch.I had a 450 Antec where all the Motherboard Standoffs Is the power supply switched on? By booting with a narrow selection of components, you bypass potential errors with a discrete graphics processor, hard drive or other peripherals. http://www.tomshardware.com/answers/id-1946762/build-boot-inside-case.html How to Build a PC Tips for PC Builders My PC won't start or boot!

Computer won't boot up inside case, but wil outside Started by GSandra32 , Mar 16 2012 10:44 AM Please log in to reply 8 replies to this topic #1 GSandra32 GSandra32 Username Forum Password I've forgotten my password Remember me This is not recommended for shared computers Sign in anonymously Don't add me to the active users list Privacy Policy

No fans/drives attempting to boot up or anything, even momentarily, just a completely dead machine. After several hours and numerous test, I finally put the old power supply back in, and everything worked fine.

Motherboard Standoffs

ALL ATX power supplies SHOULD work on ALL ATX mainboards.....but....not a perfect world....it just aint so. http://www.digitaltrends.com/computing/five-reasons-why-your-new-motherboard-doesnt-work-how-to-fix-them/ The experience you gain by replacing your mobo gives you the potential to use the same computer for a decade (or more) by replacing the internals when necessary. Motherboard Works Outside Of Case But Not In How Does a computer get Infected? Psu Pins 11, 12, 23, and 24 are the four pins added at the far end.

Pay attention to signs of damaged or misaligned SATA ports, if you experience hard drive issues. his comment is here Any ideas? I'm using a heat pipe that clips on, so that will be kind of hard to get off (I feel like I'm going to break the clips or worse whenever I Login now.

Already have an account? Rosie Rabbit Resolved HJT Threads 31 02-20-2011 07:35 AM Computer won't boot, just restarts. The only change is the pin number. this contact form I have tried most things you've posted, the only last thing that makes sense is that the board has blown.

In addition to the machine being "dead", I noticed that there is a green light on the motherboard that remains on when the machine is plugged in with the PSU turned I had plugged everything in several times, trying different orientations and what not, making sure everything is in right, but nothing will turn on except the mobo LED light on the I'm afraid I do not have much technical knowledge, so please bear with me!

This leads to the original problem again.

You may also... SHOW ME NOW CNET © CBS Interactive Inc.  /  All Rights Reserved. Resolving an issue is usually fairly simple, the problem lies in finding it, which usually involves testing different possibilities. Therefore, there are multiple factors that must...

Seems like more trouble honestly) but the same thing happened to me and then I realized I forgot to plug in the CPU power. Sep 23, 2008 #9 nickc TechSpot Paladin Posts: 923 +11 a $50. Thanks for any help. http://macland.net/power-supply/power-supply-fan-antec-p182-case.php Outside of the chassis it's booting up (fan spinning and power button on MoBo glowing)and telling me the BIOS and been resetted and how i want to proceed.

Have you figured out a solution at all? Still wondering if that is a optimistic sign that at least the mobo has a chance of not beingg fried. No, create an account now. Read More .

After everything is unplugged, try to turn on the system. geofeltFeb 4, 2012, 2:58 AM hwhite1725 said: I actually did consider this, just forgot to add that I had tried it. Just disconnect the side fan for the moment, not likely part of the problem but also not connected properly.Basically lets strip the system down to do some logical step by step Step 5) Install windows and attempt to re-install in case.

Now it won't start up, just flashes the case lights fast and doesn't boot. power supply voltage, 2. I would be hesitant to try replacing the MOBO alone, considering the possibility that one or more of the cards (video, etc), or the CPU are bad, and may blow out Thank you Sep 23, 2008 #7 nickc TechSpot Paladin Posts: 923 +11 if the mother board is blown the only fix is to get a new mobo.