Printer Doesn't Power On- Any Hope?
And as long as I shut it down for no more than a few minutes it started up again. At my first try of power up, the ready light stayed on long enough that I was able to get the "self test" printout after depressing the purple button.Can't duplicate now by moe on Mar 16, 2010 at 5:38pm Add comment Please sign in to comment Moe, Will this work with the dreaded P2015 Formatters? Järgmisena Memperbaiki Main Board Printer Epson - Kestus: 3:45. http://macland.net/hp-printer/printer-doesn-t.php
HP Printer Support 187 612 kuvamist 10:44 Printer won't print - Kestus: 2:29. Now hoping that is a fault of the power on/off switch, or worse, the logic board itself. Do not use a power strip or surge protector. Used a hairdryer to warm the printer up and it woke up again when I connected power ... - williew 0 its a main board problem by Anonymous on Aug 23, http://support.hp.com/us-en/document/c01321436
Canon Printer Won't Turn On
That is what I would like to do next.Can anyone on this thread advise how to get this open (without totally destroying it!)RegardsGaryReplyDeleteRepliesAnonymousSunday, December 1, 2013 at 9:29:00 AM GMT+2remove securing I have only had the covers off so far but will disassemble it further when I get the chance. If you need to obtain a compatible power cord or you need to replace the power cord, go to the HP Parts Store. PC World Forums > PressF1 > Canon PIXMA iP4000 - no power-on light PDA View Full Version : Canon PIXMA iP4000 - no power-on light Robin S_05-04-2011, 12:50 AMI have been
- initially the other machines were taken back to the store and told they were crap, only hope it wasn't a swindle, lol.
- Any help for us just out of warranty?
- Jul 5, 2011 #2 Mugsy TS Guru Topic Starter Posts: 365 +10 Direct Thanks for the reply.
HP Printer Support 196 069 kuvamist 6:04 scrapping a printer power supply scrapping tips - Kestus: 6:05. If the power indicator light is still turned off when connected with a new power cord, skip to Service or replace the printer at the end of this document. If the wall outlet works, continue with these steps. Printer Won't Turn On Brother Yesterday, I quickly "aborted" a print job on my Canon ip4500 usb inkjet printer by pressing the power button on the front of the unit.
Problem was evident as soon as I pulled up. It's a bit worrying that the solution is ritual rather than engineering (discuss sometime...) The ritual produced signs of life for a second or so. Support Forum Join the conversation!
If there is a "wall wort" or "brick" on the power line do you have a multimeter to check that it is delivering the correct (or slightly higher) voltage that it
Maybe I will try some things... Hp Printer Will Not Turn Off On the cover you will see a small silver hex-head screw. Replace the power cord. I'm in Australia.
Hp Printer Won't Turn On
I used a hair dryer to heat up the printer (mostly the bottom with the circuit board) for several minutes and then plugged it in.Started up again and prints just fine. I was delighted! Canon Printer Won't Turn On It just went completely dead, as if the power cord was unplugged. Epson Printer Won't Turn On I asked if they had something special about their receptacles but was told they were just standard 110 voltage outlets like I have in my condo.
I can't believe this!!!! weblink Let it go to sleep and then printed a test page again and it woke up and printed fine!How long this will last,dunno!I already bought a Lexmark E250dn duplexing laser printer Did this answer your question? If the problem continues Ithink service will need to take a look. Hp Printer Power Supply Problems
and perhaps the power outage had blown a circuit board, meaning the whole printer would be replaced. The printer is 18 months old. If a replacement power module is available, but you do not want to replace it, skip to Service or replace the printer at the end of this document. navigate here I have pulled the printer apart and checked the power supply, the voltages are the same as mention in the previous post.
yes I'm another faithful HP Laserjet 4L owner who has owned his 4L for 18 years now and I still use the best operating system microsoft ever created... My Hp Printer Keeps Turning On And Off Me too Report Inappropriate Content Message 1 of 33 (14,824 Views) Reply 2 Kudos Ramona Product Expert Posts: 1,794 Registered: 10-17-2012 Re: Our 6 month old Cannon Pixma MG5320 died, won't Wasn't the plug, wasn't the breaker, wasn't the outlet.
to no success.
Jan 8, 2012 #6 Bob A TS Rookie Did anyone write down the voltages they got from the power supply? then hit the ON button. I aborted print jobs this way for years with the HP printer I had before this one, so never suspected this could damage my printer. Hp Printer Power Supply Replacement Surprising.
But this whole effort took less than 10 minutes, and I can say my printer is now working just fine again. I located 3 fuses on the board, and I checked each one of them for continuity. Xerox.com Support Community Register Sign In Help Support & Drivers MySupport Products & Services Customer Support Forum Support Forums Printing Xerox Colorqube 8570 won't power up his comment is here All rights reserved.