Home > Computer Won 39 T > Problem With Computer Starting Up

Problem With Computer Starting Up

Contents

I believe if the hard disk is good, you should re-install the Windows. Report DJ AKSHAY 266Posts Sunday December 21, 2008Registration date April 26, 2010 Last seen - Jan 24, 2009 at 01:40 AM Yes, you can buy any P4 compatible cooler fan for Turn on the computer and press f10 to boot into the BIOS Setup and select Hard Disk Test. Try to reset the BIOS then try again. http://macland.net/computer-won-39-t/problem-starting-my-computer-up.php

I strongly suggest that you go into System->Advanced Startup Options and uncheck the box to automatically restart. The one which students use. Loading... Apart from high powered power supplies which have a knob to regulate the fan's speed but still the fan itself cannot decide to change its speed by itself.

Computer Won't Start

Windows 7, Vista , or XP operating system Depending on the condition of the hard drive, the recovery utility allows you to make a backup of all of your personal files or at all. The System Restore process starts and returns system settings to a time when it worked correctly.

  1. CD drive runs fine removed the CMOS battery power is fine screen is fine fan runs fine keyboard works fine changes the BIOS setting switched off USB legacy & wireless nothing
  2. If the monitor lead connects to your computer in the same area where all the other leads plug in, then your computer does not have a separate video card.
  3. If you have one, the Windows DVD can be used, but otherwise you can download (using another computer – obviously) a rescue disc image and either burn it to a CD
  4. Repair Your Computer allows Uninstall recently installed software programs Windows to run diagnostic tests.
  5. Report miamisnoopy305- Jun 29, 2009 at 03:03 AM Thank you sooooo much.
  6. If you can see the coloured wires inside the black outer protection, it could be time to buy a new PSU.

this makes me think the memory is fine as the CD loads onto memory fine. This should pull less lower off the supply. Once the correct driver is installed you can select the desired resolution. Computer Won't Boot Windows 10 I will try eraser trick .I suspect since I hadnot unplugged VGA monitor cable that caused the static electricity as using pc100 (128MB) still wount boot.

You must have the Windows Operating System Disc (OSD) provided with your HP computer to repair the Master Boot Record (MBR). Computer Won't Boot Windows 7 You can then boot from this and attempt to fix the problem with Windows. More "Computer Won't Turn On" Tips Still can't get your computer to turn on? http://www.howtogeek.com/173828/what-to-do-when-windows-wont-boot/ No usual beep, nothing.

Double-check, too, that the charger is the right one for your laptop. Computer Won't Boot Up Black Screen Thanks Rick - UK (00:20) Report ca› DJ AKSHAY - Apr 17, 2009 at 09:44 AM what if my computer doesnt beep at all when it always beeps on startup. Report buju› COOL DJ - Mar 17, 2009 at 08:44 AM my computer powers on but the there is no light in front of the cpu can u help me solved cleaned the terminals - still nothing tried the touch test on the processor - get HOT!!!

Computer Won't Boot Windows 7

On newer computers, connecting the wrong adapter might cause the power LED lights to blink but not power the computer. http://www.leoisaac.com/tec/main006.htm Unless you get a message indicating an error in the memory, or you’re an experienced user, there is not much of a reason for running this test.  The computer will restart Computer Won't Start If you cannot do that, use a DMM to measure the voltages. Computer Won't Turn On In the absence of a single short beep, they also do not indicate that the system is booting.At this point, you can sort of check the PSU.

Can u get fujistu siemens motherboard manual they have no online manual Report tusri 2Posts Wednesday September 30, 2009Registration date October 19, 2009 Last seen - Oct 19, 2009 at 02:11 http://macland.net/computer-won-39-t/problem-starting-my-system.php While you've got the case open, reseat ram, and tighten connections.When it does start up, go into the bios and try turning the clocks back to stock (there should be a Data recovery after the fact is usually iffy at best and may be expensive or impossible if the drive itself has gone south or the data corrupted beyond all recognition.

October You can try pulling the computer's hard drive, inserting it into another computer, and recovering your files that way. Computer Not Powering On

If this works, then you know for sure that the additional video card is broken. At first I powered down, bled power and it would get to the "Sorry, windows did not shut down...Safemode...last known...and the countdown" page but no matter if I let it rundown Loose cable Particularly if your have been moving a computer around, or you have opened the case for any reason, it is perfectly possible that a cable is loose or there have a peek at these guys If you have just replaced any internal hardware components (memory modules, hard drive, etc.) and you experience a blink or beep code, the component might not be connected properly.

In Windows XP Click Start, All Programs, Accessories, System Tools, System Restore. My Laptop Wont Start Up Just A Black Screen Two things: 1. after two hours going in circles with HP support another 2 hours searching the web.

Loading...

Perform a hard reset If the computer suddenly fails to startup properly, perform a hard reset as the first action. Please send your reply to Email Id removed for security Report seekeroftruth- Apr 8, 2009 at 11:25 PM I've had a similar problem with this new computer, and two to three I wait and wait. Computer Has Power But Wont Turn On Please reply via E-mail, or here if more convenient.

So, the way that I understand it, is the the motherboard or processor is the issue. Category How-to & Style Licence Standard YouTube Licence Show more Show less Loading... A good computer fixer/repairer may well be able to repair the missing or corrupt file problem. http://macland.net/computer-won-39-t/problem-starting-up-pc.php Report Dmt94666- Jul 9, 2009 at 09:14 AM Hi I removed my memory and theres no beeping sounds also I had a look at my processor and it has some chips

However, you could just try plugging in the monitor to other (not in use) video monitor port (see yellow arrow). Report DJ AKSHAY 266Posts Sunday December 21, 2008Registration date April 26, 2010 Last seen - Jul 30, 2009 at 11:45 AM Hi, I read about your problem... Z7_3054ICK0KGTE30AQO5O3KA30H5 hp-country-locator-portlet Actions ${title} Loading... Can you help?

If your computer works with only the essential hardware installed, add pieces back one at a time, testing each time to see where the problem lies. The Temperature sensor for your processor is preventing damage to your Processor because the fan are not being able to cool it down properly. It might be necessary to press and hold the power button for 15 seconds or more to force the computer to shut down. Maybe the case was not in your article.

October 23, 2013 Naman Sood Try reinstalling Windows.

August 17, 2015 Matthew Norvell I restarted the computer after installing Windows 10 and

But due to work, I only get time at night to help you people out. Occasionally, people have found that removing the drive and putting it in the freezer for a couple of hours (in a freezer bag) does the trick. Image Credit: Karl-Ludwig G. Nothing.

Test the hard drive.